Ultra Sharp Diamond Coated Pin + Double Ended Vice For Cleaning & Restoring Coins

Ancient Coins - Ultra Sharp Diamond Coated Pin + Double Ended Vice For Cleaning & Restoring Coins
zoom view
PRICE IS FOR 1 PIN AND 1 Pin Vice. I have pre-installed the pin into the vice for convenience.
 
 
The entire line of cleaning pins as well as our famous cleaning pencils can be found in our store
 

SUPER SHARP POINT DIAMOND PIN

This blue portion is specifically for the SUPER SHARP Point pin in this listing. The paragraph below applies to all of the diamond pins that we sell in our store. Have you ever tried to clean the extremely small detail on a coin? Often times the tool you are using simply is not fine enough to fit into the devices of letters, hair, folds of drapery and the like. If you've ever tried using sewing needles, you may have had limited success but found that they bend very easily and dull quickly. What you have found here is a solution to these problems, a pin hard enough to not bend and will never dull! This SUPER SHARP pin is coated with the same super fine grit diamond that our original pin is coated with (which we've sold hundreds of and which every single buyer has been very pleased by). The yellow band on the collar always means super fine grit, the finest that can be obtained. hat makes this pin different is that the point is so incredibly sharp that one can use it clean the finest of detail! If you look at the images briefly, you can see that the point is small enough to easily fit between the fine hairs on President Roosevelt's head (this is an example only. don't clean your dimes with these tools)! Our original pin is a tiny .5mm at the point, small enough for most work and general usage. This pin takes it to whole new level; this pin is only .2mm at the point, which is (in general) smaller than the crevice of any detail on any coins you'd ever want to clean. With this tool you can remove that dirt and bring a crispness to your coins not possible before. ONE SHOULD OBVIOUSLY USE MAGNIFICATION every time they use this tool. You should also never point this pin directly at the coin as it will absolutely cut into the coin and leave a very bad scratch. Because of the extremely fine point on this particular pin one will need to replace it more frequently than our other pins; there simply is less area for the diamond to bind to at this extremely small point and thus it will wear away quicker. The metal beneath is still more useful than a sewing needle, so even if you don't replace it right away it will still be somewhat usable.

 
 
If you've been cleaning artifacts and coins and you've come across some very hard encrustations, you've found the perfect tool for dealing with it! Unlike the other pin tool we sell (which has a fine grit, and is great for all-purpose removal of dirt and grime) this pin tool has a much coarser grain of diamond. The action of the pin is thus much more abrasive. What this equates to is a tool that can be used to grind away hard encrustations, corrosion and deposits from the coin! If used properly, one can grind the corrosion / encrustation down to the surface or near to the surface of the coin or artifact. One can accomplish this by using small circular motions, working parallel with the surface (using the side of the pin, not the point). I absolutely recommend doing so under magnification so as to avoid scratching other areas of the coin. I must give you a word of caution about this pin. Unlike the other one I sell, which is fairly safe on most patinas with gentle pressure, this one will wreck the patina and scratch the coin if you are not careful. The extra-coarse grit is meant for heavy encrustations, not for general dirt. I do not recommend this pin to beginners, and I suggest that even a seasoned pro should practice using this before working on good material. This pin is intended for use on bronze and brass coins only. I do not recommend using this on silver coins because it is can very very easily scratch them. I make no guarantees as to the results you will have on your coins.
 
 

This listing is for the pin and a double ended pin vice (which is necessary to hold the pin). These pins measure 23mm long (.906 inches) and 1.6mm wide. The vice is about 4 inches long.


These pins are sold as-is with the only warranty being that the pin will be as pictured and will be of high quality. They are manufactured to the HIGHEST degree of quality. With that being said, through normal use, eventually the diamond coating will wear out and the pin will need to be replaced (and you can obtain them here). Giving you an estimate as to the lifespan of the pins is not possible due to varying frequency and intensity of use, but you can expect to clean many coins without needing to replace it. Even after the diamond coating is gone, the pin can be used to flick away dirt and clean devices, though with much reduced effectiveness. It is normal for the tip of the pin to wear out first, while the diamond further down the shaft will remain intact One can use the diamond on the shaft to grind the dirt on the edge of the coin after the tip has been used, but the tip will lose much of its effectiveness and you'll need to obtain a replacement.

 
IF YOU HAVE ANY QUESTIONS, PLEASE FEEL FREE TO ASK.
Ancient Coins - Ultra Sharp Diamond Coated Pin + Double Ended Vice For Cleaning & Restoring Coins
Ancient Coins - Ultra Sharp Diamond Coated Pin + Double Ended Vice For Cleaning & Restoring Coins
Ancient Coins - Ultra Sharp Diamond Coated Pin + Double Ended Vice For Cleaning & Restoring Coins
Precio SKU: SHARPVICE
US$ 33.00
  • € 29.92
  • £ 26.40
  • AUD 48.60
  • CHF 32.74
  • CAD 43.79

Cotización al: 09/23/19

Envía desde: United States